G2SC-318-B 3-3/16" Black Oxide Two-Piece Clamping Shaft Collar 24mm ID For applications involving slow rotating

For applications involving slow rotating or linear motion

Allows you room to re-bore the ID without damaging the clamp screws

Acetal Copolymer collars will not rust or corrode

Traditional cost effective rigid coupling design

Extra thick non-conductive rubber liner corrects misalignment up to 2° while reducing noise & vibration

G2SC-318-B 3-3/16" Black Oxide Two-Piece Clamping Shaft Collar 24mm ID For applications involving slow rotatingDesign fully engages the shaft without marring. Easily installed where major disassembly would otherwise be required. Provides greater axial holding power than set screw or one piece clamping collars. Effective on both hard and soft shafts. View Catalog Page